Water heater Hendi 240700

This 25-litre Hendi water heater prepares hot water or mulled wine, with thermostat control up to 110°C. Its capacity is larger than most products in this category, providing a substantial reserve for service before replenishment is needed.

Where it is used

At a hotel breakfast station or buffet, the stored hot water supports repeated cup service from one vessel. Insulated polypropylene handles reduce direct heat transfer to the grip, while the non-drip tap helps limit drops around the serving point.

Allow about 75 minutes for water to reach boiling and start heating ahead of the planned service. The heater is not intended for preparing hot chocolate, so use a separate method for that task.

Connection and installation

The 230 V operating voltage helps identify a suitable supply arrangement for the drinks station. Its 2.5 kW rated power is the electrical load to account for when planning that supply.

The thermostat regulates heat against a selected setting, up to 110°C. Staff can adjust the heat for hot-water or mulled-wine preparation rather than relying on an uncontrolled heating cycle.

Care

The stainless-steel vessel resists corrosion in normal damp-kitchen conditions and has a cleanable surface. This makes it suited to repeated water service and routine kitchen care, where keeping the vessel clean is part of maintaining a ready drinks station.

How to choose

Overall dimensions of 442 × 426 × 491 mm define the counter footprint to allow for when arranging the service station. The 25-litre capacity is larger than most products in this category, making the heater a useful choice where a substantial hot-drink reserve is needed.

The thermostat’s upper limit of 110°C supports hot-water and mulled-wine preparation. The roughly 75-minute boil-up period suits a service schedule that can begin heating in advance.